Return to the BUILD

“During this stage, you will fit the seat belts. Even a top of the range two-seater like the LaFerrari would be incomplete without safety equipment for the driver and passenger.“

Contents

Parts

Build

The Seat Belts

Step 1

Press fit the two pins of the Rear Window Rear Bezel into the matching posts of Rear Window Front Bezel, as shown:

Step 2

Retrieve your Cockpit Floor assembly from Stage 19. Fit the pins and posts of this Rear Window Bezel assembly into the matching holes at this location in the upper rear deck of the Floor, as shown:

Step 3

Secure the Rear Window Bezel into place from below with three (3) Type B screws:

Step 4

Press the pins on the upper ends of the Seat Belts into the matching holes at these locations on the Cockpit Floor:

Press the pins on the lower ends of the Seat Belts into the matching holes at these locations on the Cockpit Floor:

With the Seat Belts fitted, I temporarily installed my Seats to see how the Belts would lay on them. I found that there was a twist in them that I wanted to remove. I did this by disconnecting the upper end of the Seat Belts, twisting them 180° through the slot, and popping them back in:

This is how my Seat Belts now lay across my seats, with the belt buckles facing inward:

Thoughts

With these Seat Belts and rear Window Bezel installed, I feel we are quickly approaching the final stages of building our Interior. Keep this assembly (and the tiny “Limited Edition” Plate) stored safely as this stage completes Pack 3.

Next Up

 Stage 25 – Rear Window, Cylinder Block, Alternator Parts